Owner manual

OPTIONAL COMPONENTS

Temperature recorder

An automatic temperature recorders is available for this freezer as the optional component. The type of

the recorder is MTR-G85.

Following shows the attachment procedure.

1. Remove four screws on the front panel and take it off.

By removing four screws, take off the left side panel.

Then take off the cover for the recorder mounting space

by removing four screws. (Fig. 1)

2. As shown in the Fig. 2, insert the temperature

recorder to the mounting space and fix it to the back

side of the front panel by using the recorder fixture

enclosed with the recorder.

3. Take off the recorder sensor cover in the chamber

(bottom left side) by removing two screws. Then

remove the rubber cap and insulation covering the

sensor port. (Fig. 3)

4. As shown in the Fig. 4, pass the recorder sensor

through the sensor guide pipe from the front to the back.

The sensor guide pipe is provided on the upper left side

of the base compartment.

5. Take out the recorder sensor from the guide pipe at

the back side and pass the sensor to the chamber

through the access port. (Fig. 5)

6. Attach the recorder sensor on the sensor cover with

the enclosed clips. Seal the sensor port with a silicon

and replace the recorder sensor cover. Fix the cover

to the inside wall. (Fig. 6)

7. Remove the connector cover. Connect the recorder

connector at the end of the power cord with the white

connector on the left of the base compartment. Bind

the extra lead wire of the sensor with a nylon clip on the

back of the recorder. (Fig. 7)

8. Replace the left side panel and front panel and fix

them with screws.

Fig. 2

Fig. 3

Fig. 4

Fig. 1

Fig. 5

Fig. 6

Fig. 7

connector

Sensor guide pipe