User`s manual

User's Manual
16
9. Trouble Shooting
Problem
No display light up on front
panel
No sound or picture, but the
front panel red light is ON
No sound or picture
Bad picture/Blocking Error
No picture(Video)
There is interference on your
digital satellite channel
The RCU is not working
What To Do
Check to make sure power cord
is plugged properly into power
socket
Press the standby button
Adjust the dish. Check the
Signal Level in the Antenna
Setup Menu
Check the cable connections.
LNB and other equipment
connected between the LNB
and the receiver and adjust the
dish
Adjust the dish
Connect a signal attenuator to
the LNB input
Change to a larger dish
Change to an LNB with lower
noise factor
Change the LNB
Check the UHF channel fixed in
your system and tune the UHF
properly
Change the receiver output
channel to a more suitable
channel or connect the system
using SCART cable
Change the battery
Aim the RCU at the unit, and
make sure no blocks between
the front panel and RCU
Possible Causes
Power Cord is not well
plugged
The unit is in standby mode
The satellite dish is not
pointing at the satellite
No signal or weak signal
The satellite dish in not
pointing at the satellite
Signal is too strong
Satellite dish is too small
LNB noise factor too high
The LNB is faulty
The system is connected by
SCART cable and TV is not in
AV/EXT mode
The system is connected
using RF cable and the output
channel of the receiver
interferes with an existing
terrestrial channel or Video
Signal
Out of battery
RCU is aimed at wrong
direction
Note: If you still cannot resolve the problem with above reference. Please contact the local dealer or
their after-sales service center.