Copier Operating Instructions

User Tools (System Settings)
16
2
Settings You Can Change with the User
Tools
For details on how to display the settings, see p.13 “Accessing the User Tools
(System Settings)”.
General Features 1/3
❖
❖❖
❖ Fusing Adjustment: Paper Tray
Specifies the characteristics of the paper roll in the paper tray. If the image on
copies is scratched, or the paper wrinkles when using translucent paper, you
can change the setting to get better copies.
You can specify separate settings for Plain, Translucent paper, and Film.
Note
❒ Default: 3
❒ The paper thickness can be set from 1 (Thicker) to 5 (Thinner).
❒ Refer to the chart below when selecting the mode for the paper thickness.
*1
Out of guarantee
❒ Depending on the type of paper and the operating conditions, the toner
fusing condition changes. To improve the toner fusing, change the mode
setting to 3→2→1.
❒ When using thin paper, or soft, limp paper, the toner fusing may be wrin-
kled or the image may be blurred. In these cases, change the setting to
mode 3→4→5.
❒ When using Film, do not set to mode 5.
Mode12345
Paper Type
Plain paper
110g/m
2
(29.3 lb)
90g/m
2
(23.9 lb)
70g/m
2
(Standard
mode)
(18.6 lb)
60g/m
2
(15.9 lb)
50g/m
2
(13.3 lb)
Translucent
paper
70 – 90g/m
2
(18.6 – 29.3 lb)
70 – 80g/m
2
(18.6 – 21.3 lb)
70 – 80g/m
2
(18.6 – 21.3 lb)
(Standard
mode)
50 – 70g/m
2
(13.3 – 18.6 lb)
50-60 g/m
2
(13.3-15.9 lb)
*1
* If the paper wrinkles when using mode 3,
try using mode 2 or mode 1.
Film 0.07mm –
0.095mm
(2.8 Mil – 3.7
Mil)
0.07mm –
0.095mm
(2.8 Mil – 3.7
Mil)
0.07mm –
0.095mm
(2.8 Mil – 3.7
Mil) (Stand-
ard mode)
0.07mm –
0.095mm
(2.8 Mil – 3.7
Mil) (Stand-
ard mode)
—
DolphinGB-Syst-F_V4_FM.book Page 16 Wednesday, May 2, 2001 1:19 PM