Owner manual

SawStop 10” Industrial Cabinet Saw 9
(On saws with 230V, single phase motors.)
(On saws with 480V, three phase motors.)
!
WARNING
-OVINGBELTSANDPARTS
CANPINCHCUTORCRUSH
$ONOTOPERATEWITH
DOOROPEN
,OCKOUTBEFORESERVICING
(On saws with 230V, three phase motors.)
(On saws with 600V, three phase motors.)
Connect Only 208-240 Volts,
Single Phase Power.
This machine must be connected to an
electrical ground in accordance with the
National Electrical Code. Failure to connect
to an adequate ground may cause the
safety system to malfunction and
could result in a serious injury.
!
WARNING
Connect Only 208-240 Volts,
Three Phase Power.
This machine must be connected to an
electrical ground in accordance with the
National Electrical Code. Failure to connect
to an adequate ground may cause the
safety system to malfunction and
could result in a serious injury.
!
WARNING
Connect Only 460-480 Volts,
Three Phase Power.
This machine must be connected to an
electrical ground in accordance with the
National Electrical Code. Failure to connect
to an adequate ground may cause the
safety system to malfunction and
could result in a serious injury.
!
WARNING
WARNING
!
1. Use the blade guard and spreader for every
operation for which it can be used.
2. Use the riving knife for non-through sawing.
3. Keep hands away from the saw blade. Use a
push-stick when required.
To avoid loss of SawStop
protection during coast down,
do not turn off Main Power until
blade has stopped spinning.
WARNING
!
Connect Only 575-600 Volts,
Three Phase Power.
This machine must be connected to an
electrical ground. Failure to connect
to an adequate ground may cause the
safety system to malfunction and
could result in a serious injury.
!
WARNING
Industrial Cabinet Saw Rev. 2 Ma9 9 3/9/2010 8:38:29 AM