Owner manual
16 SawStop 10” Industrial Cabinet Saw
Setting Up Your Saw
1. Saw Placement:
Position the saw on a level surface away
from sources of moisture and electrical noise.
Make sure there is sufcient room to allow
free access to all sides of the saw.
If you plan to relocate the saw occasionally,
mount the saw in the optional SawStop
Industrial Mobile Base (see Fig. 6). This
mobile base has been specically engineered
to t the Industrial Cabinet Saw and to
support the weight of the saw including the
optional T-Glide Fence, Rails and Extension
table. See the Owner’s Manual included with
the Industrial Mobile Base for instructions on
mounting the saw in the base and operating
the base.
3. Table and Extension Wing Cleaning:
The table and extension wings are shipped with a coating of oil on the top surfaces to prevent the cast iron
from rusting. Carefully wipe the top surfaces with a soft, clean cloth to remove the oil. To prevent the top
surfaces from rusting during use, you can coat the surfaces with rust-preventative materials such as TopCote
®
or TopSaver™, available in many woodworking stores. If the saw will not be used for an extended time, the
table and wing surfaces can also be protected by applying a light coating of oil and then covering with wax
paper.
4. Rip Fence Installation:
This saw ships without a rip fence. You must install a rip fence prior to using the saw. Refer to the manual that
accompanied your rip fence for instructions on installing the fence on the saw.
2. Extension Wing Assembly:
The saw is shipped with the right extension wing
pre-installed. Position the left extension wing next
to the table, making sure the small beveled edge
on the surface of the extension wing is facing
forward. Insert the three M10x1.5x30 bolts (with
washers and lock washers) through the holes in
the side of the wing and into the threaded holes
in the side of the table (see Fig. 7). Align the
top of the extension wing with the table using
a straight edge and then fully tighten the bolts
using a 17 mm wrench. You may want someone
to help hold the extension wing in place while
you fasten the bolts.
Fig. 7
Fig. 6
Industrial Cabinet Saw Rev. 2 Ma16 16 3/9/2010 8:38:34 AM