Owner manual

SawStop 10” Industrial Cabinet Saw 19

Setting Up Your Saw

Note: some users may nd it easier to adjust the brake position by opening the motor cover and removing the

dust shroud door to see the blade and brake cartridge more clearly. To remove the dust shroud door, loosen

the thumb screw and lift the door upward until the pivot pin in the door clears the pivot hole in the cast iron

trunnion brace (see Fig. 11).

Using the 8 mm hex L-wrench included with the saw, turn the spacing adjustment bolt clockwise to decrease

the spacing between the brake cartridge and the edge of the blade, and counter-clockwise to increase the

spacing. Adjust the brake position as needed to set the spacing between the teeth of the blade and the closest

point on the brake cartridge to between

16 inch and

8 inch (see Fig. 12).

A close-up of the area

inside the circle is shown

in Fig. 13, on page 20.

Setting Up Your Saw

Fig. 11

Fig. 12

dust shroud door

thumb screw

Industrial Cabinet Saw Rev. 2 Ma19 19 3/9/2010 8:38:36 AM