Owner manual

42 SawStop 10” Industrial Cabinet Saw

You can change the brake cartridge either from the top of the saw through the table opening, or from the right

side of the saw through the opening behind the motor cover. To change the cartridge from the right side, rst

open the motor cover. Next, remove the dust shroud door by loosening the thumb screw at the front of the door

and lifting the door upward until the pivot pin clears the mounting shaft. See Fig. 11 on page 19.

The brake cartridge is mounted on a large pivot pin

and a smaller positioning pin as shown in Fig. 42.

Both the pivot pin and positioning pin extend

outward from a cartridge mounting bracket that

sets the position of the cartridge. The cartridge

mounting bracket also holds a computer cable

that self-aligns to the computer connector in the

side of the cartridge. A cartridge key is used to lock

the brake cartridge in place against the cartridge

mounting bracket.

Removing a Brake Cartridge: to remove the

cartridge, rst remove the cartridge key by turning

it 90° clockwise and then pulling it away from the

cartridge (see Fig. 43). Set the cartridge key aside

for use with the new cartridge.

It may take a small amount of force to turn the key

and pull it out. Make sure you turn the key a full

90°, as the key cannot be pulled out unless it has

been fully rotated.

Using Your Saw

Fig. 42

pivot pin

cartridge

key

positioning

Fig. 43

Industrial Cabinet Saw Rev. 2 Ma42 42 3/9/2010 8:38:50 AM