Owner manual

SawStop 10” Industrial Cabinet Saw 77
Auxiliary Fence Construction
This diagram illustrates an auxiliary fence for use with the push block shown on page 76. Cut piece A out of
3
/
4 inch plywood and cut piece B out of
1
/
2 inch plywood. Position piece A along
the edge of piece B as shown in the drawing on the left, and attach it using wood glue and counter-sunk wood screws. To use the auxiliary fence, place it on the saw with piece B at on the table top and piece A against the left side of the rip fence. Position the auxiliary fence so that the front edge of piece B is 1- 2 inches back from the front edge of the table, and then clamp piece A securely to the rip fence. Position the rip fence so that the spacing between the left edge of piece B and the blade is the width you want to cut, and then lock the rip fence in place. Slide the workpiece along the edge of piece B closest to the blade. If your hand comes within 6 inches of the blade, remove your hand from the workpiece and use the push block to nish the cut.
B
A
B
A
24"
2”
24"
5 1/2”
(3/4” thick) (1/2” thick)
Industrial Cabinet Saw Rev. 2 Ma77 77 3/9/2010 8:39:06 AM