Owner manual
SawStop 10” Industrial Cabinet Saw 7
10. Do not try to force the saw to do something it was not designed to do. For example, do not try to cut wood faster
than the motor can handle, and use the right blade for the job.
11. Wear proper apparel when using the saw. Do not wear loose clothing, gloves, neckties, rings, bracelets, or
other jewelry which may get caught in moving parts. Non-slip footwear is recommended. Wear a protective hair
covering to contain long hair.
12. Always wear safety glasses when using the saw. Also use a face or dust mask if the cutting operation is dusty.
Everyday eyeglasses are not safety glasses.
13. Do not overreach or stretch to get something when using the saw. Keep proper footing and balance at all
times.
14. Maintain the saw as specied in this manual.
15. Turn the power disconnect switch to OFF before servicing the saw and when changing components or
accessories such as blades, brake cartridges, and the like.
16. Use only recommended accessories with the saw. Consult this manual for recommended accessories. The use
of improper accessories may cause risk of injury to persons.
17. Never stand on the saw. Serious injury could occur if the saw is tipped or if the cutting tool is unintentionally
contacted.
18. Check to make sure the saw is in proper working order before using the saw. For example, check the alignment
of moving parts, look to see whether moving parts are binding or rubbing, check to see whether parts are broken,
make sure accessories are properly mounted in the saw, and check any other conditions that may affect the
operation of the saw. A guard or other part that is damaged should be properly repaired or replaced.
19. Feed work into the blade or cutter against the direction of rotation of the blade or cutter only. Feeding the work
in the direction of rotation may cause the work to be thrown by the blade and could result in serious personal
injury.
20. Never leave the saw running unattended. Wait until the blade comes to a complete stop, and then turn both the
Main Power switch and the Disconnect switch to OFF when you are nished using the saw.
21. This saw is packaged without a rip fence. You must install a rip fence before using this saw. Attempting to use
the saw without a rip fence could result in a serious personal injury.
22. Always maintain rm control over the material being cut. Never cut any material freehand.
23. Never operate the saw with the access doors open. Do not attempt to bypass or defeat the access door
interlock switches.
WARNINGS
!
Industrial Cabinet Saw Rev. 2 Ma7 7 3/9/2010 8:38:29 AM