Assembly

13. Locate the main tube and remove seven M8x1.0x16 hex head bolts, seven M8x23x2 washers, and seven

M8 lock washers from the fence assembly hardware pack. Position the main tube on the horizontal portion

of the front rail with the rulers facing up and the 12 inch ruler on the left. The powder coated surfaces of the

main tube and rail can be slick, so be careful that the main tube does not fall off the rail. Align the holes in the

rail with the holes in the bottom of the main tube. Place an M8x23x2 washer and an M8 lock washer on each

M8x1.0x16 hex head bolt and insert the bolts through the rail and into the threaded holes in the bottom of the

main tube (see Fig. 13). Hand tighten the bolts; do not fully tighten them.

14. Locate the fence and the red fence handle. Thread

the handle into the cam lock on the front of the fence

(see Fig. 14).

Fig. 13

Fig. 14

Installing Your Fence Assembly

thread the handle into

the cam lock

SawStop

SawStop Premium Fence Assembly 7