Instruction Manual

Adjusting Your T-Glide Fence System

Once the left face plate has been removed, you can access the screws for the right face plate through the key-

hole slots for the left face plate (see Fig. 30). Loosen each screw in the right face plate just enough to allow the

face plate to slide against the fence, but tight enough so the face plate does not move freely. Install the fence

on the front tube and position the right face plate as desired, making sure to leave at least a small gap between

the bottom of the face plate and the table so the face

plate does not drag on the table.

Next, carefully lift the fence off the front tube and place

it on the table with the right face plate facing down.

Make sure not to move the face plate from the position

you set it. If necessary you can clamp the face plate to

the fence to keep the face plate from moving. Tighten

each screw to lock the right face plate in position.

Make sure not to over-tighten these screws as it

that may cause a slight concavity in the surface of

the face plate near the screw.

Replace the left face plate onto the fence and install

the fence on the front tube. Adjust the position of the

left face plate as desired. Lift the fence off the tube

and set it on the table with the left face plate down,

making sure the position of the face plate doesn’t

move. Tighten the screws to lock the left face plate

onto the fence.

Fig.

If necessary, you can adjust the position of the

indicator lenses on the front of the fence. To verify

the position of each indicator lens, clamp the

fence to the front tube and use a ruler to measure

the distance from the blade to the fence plate and

compare it to the measurement shown on the

proper indicator lens. If adjustment is necessary,

loosen the two Phillips screws shown in Fig. 31

and slide the indicator lens to right or left until the

cursor is directly over the correct measurement.

Tighten the screws to lock the position of the

indicator lens. Your fence is now fully adjusted

and ready to use.

Fig.

adjust the

indicator lens by

loosening the two

Phillips screws

SawStop T-Glide Fence System - Professional Series 15