Installation guide

WAFER-945GSE 3.5” Motherboard
Page 80
NOTE:
The SATA power cable described below is an optional item and must
be pre-ordered. The SATA power cable is not shipped with the system.
Step 4: Connect the SATA power cable. Connect the SATA power connector to the
back of the SATA drive. See
854H809HFigure 5-11. Step 0:
Figure 5-11: SATA Power Drive Connection
5.7.3 Serial Port Connector Cable (Four Ports) Cable Connection
The WAFER-945GSE is shipped with one four serial port connector cable. The four serial
port connector cable connects four serial port connectors on the cable to the 40-pin serial
port connectors on the WAFER-945GSE. To connect the four serial port connector cable
please follow the steps below.
Step 1: Locate the serial port connector. The location of the 40-pin serial port
connector is shown in Chapter 3.
Step 2: Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on