Installation guide

WAFER-945GSE 3.5” Motherboard
Page 123
 Flow Control [None]
Use the Flow Control option to report the flow control method for the console redirection
application.

None D
EFAULT
No control flow,

Hardware
Hardware is set as the console redirection

Software
Software is set as the console redirection
 Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.

Disabled
The console is not redirected after POST

Boot Loader
Redirection is active during POST and during Boot
Loader

Always D
EFAULT
Redirection is always active (Some OSes may not
work if set to Always)
 Terminal Type [ANSI]
Use the Terminal Type BIOS option to specify the remote terminal type.

ANSI D
EFAULT
The target terminal type is ANSI

VT100
The target terminal type is VT100

VT-UTF8
The target terminal type is VT-UTF8
 VT-UTF8 Combo Key Support [Disabled]
Use the VT-UFT8 Combo Key Support option to enable additional keys that are not
provided by VT100 for the PC 101 keyboard.