Installation guide

WAFER-945GSE 3.5” Motherboard
Page 170
C.1 DIO Interface Introduction
The DIO connector on the WAFER-945GSE is interfaced to GPIO ports on the ITE
IT8718F Super I/O chipset. The DIO has both 4-bit digital inputs and 4-bit digital outputs.
The digital inputs and digital outputs are generally control signals that control the on/off
circuit of external devices or TTL devices. Data can be read or written to the selected
address to enable the DIO functions.
NOTE:
For further information, please refer to the datasheet for the ITE
IT8718F Super I/O chipset.
C.2 DIO Connector Pinouts
The following table describes how the DIO connector pins are connected to the Super I/O
GPIO port.
Pin Description Super I/O Pin Super I/O Pin Description
1 Ground N/A N/A
2 VCC N/A N/A
3 Output 3 GP23 General Purpose I/O Port 2 Bit 3
4 Output 2 GP22 General Purpose I/O Port 2 Bit 2
5 Output 1 GP21 General Purpose I/O Port 2 Bit 1
6 Output 0 GP20 General Purpose I/O Port 2 Bit 0
7 Input 3 GP33 General Purpose I/O 33
8 Input 2 GP32 General Purpose I/O 32
9 Input 1 GP31 General Purpose I/O 31
10 Input 0 GP30 General Purpose I/O 30