Installation guide

WAFER-945GSE 3.5” Motherboard
Page 4
 1 x Power button connector
 1 x Reset button connector
 1 x 4-port RS-232 serial port connector
 1 x RS-232/422/485 serial port connector
 2 x Serial ATA (SATA) drive connectors
 2 x USB 2.0 connectors (supports four USB 2.0 devices)
The WAFER-945GSE has the following external peripheral interface connectors on the
board rear panel.
 2 x Ethernet connectors
 1 x Serial port connector
 2 x USB connectors
 1 x VGA connector
The WAFER-945GSE has the following on-board jumpers:
 AT Power Mode Setting
 Clear CMOS
 CF card setup
 LVDS1 Voltage Selection
 LVDS1 Panel Resolution Selection
 COM2 Port Mode setting
1.2.3 Technical Specifications
WAFER-945GSE technical specifications are listed in 747H709HTable 1-1. See Chapter 2 for
details.
Specification WAFER-945GSE
Form Factor
3.5”
System CPU
45 nm 1.6 GHz Intel® Atom™ N270
Front Side Bus (FSB)
533 MHz