Installation guide

WAFER-945GSE 3.5” Motherboard
Page 39
PIN NO. DESCRIPTION
1 +12V
2 GND
3 GND
4 +5V
Table 4-3: ATX Power Connector Pinouts
4.3.2 ATX Power Supply Enable Connector
CN Label: ATXCTL1
CN Type:
3-pin wafer (1x3)
CN Location: See
733HFigure 4-3
CN Pinouts: See
734HTable 4-4
The ATX power supply enable connector enables the WAFER-945GSE to be connected
to an ATX power supply. In default mode, the WAFER-945GSE can only us an AT power
supply. To enable an ATX power supply the AT Power Select jumper must also be
configured. Please refer to Chapter 3 for more details.
Figure 4-3: ATX Power Supply Enable Connector Location
PIN NO. DESCRIPTION
1 +5V Standby
2 GND