Installation guide

WAFER-945GSE 3.5” Motherboard
Page 71
AT Power Select Description
Short 2 – 3 Use AT power Default
OFF Use ATX power
Table 5-2: AT Power Select Jumper Settings
The location of the AT Power Select jumper is shown in 785HFigure 5-4 below.
Figure 5-4: AT Power Select Jumper Location
5.5.2 CF Card Setup
Jumper Label:
JCF1
Jumper Type:
2-pin header
Jumper Settings:
See
786HTable 5-3
Jumper Location:
See
787HFigure 5-5
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in
788HTable 5-3.
CF Card Setup Description
OFF Slave Default
Short 1-2 Master
Table 5-3: CF Card Setup Jumper Settings
The CF Card Setup jumper location is shown in 789HFigure 5-5.