Installation guide

WAFER-945GSE 3.5” Motherboard
Page 73
AT Power Select Description
Short 1 - 2 Keep CMOS Setup Default
Short 2 - 3 Clear CMOS Setup
Table 5-4: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in 833H793HFigure 5-6 below.
Figure 5-6: Clear CMOS Jumper
5.5.4 COM 2 Function Select Jumper
Jumper Label: JP1
Jumper Type:
8-pin header
Jumper Settings: See
794HTable 5-5
Jumper Location: See
795HFigure 5-7
The COM 2 Function Select jumper sets the communication protocol used by the second
serial communications port (COM 2) as RS-232, RS-422 or RS-485. The COM 2 Function
Select settings are shown in
796HTable 5-5.
COM 2 Function Select Description
Short 1-2 RS-232 Default
Short 3-4 RS-422
Short 5-6 RS-485