User's Manual
Table Of Contents
- STT-31EFI Operators Manual 03251
- GENERAL INFORMATION
- SAFETY INFORMATION
- SPECIFICATIONS
- OPERATING INSTRUCTIONS
- 4.1 Controls And Instrument Identification
- 4.2 Safety Interlock System
- 4.3 Initial Run-In Procedures
- 4.4 Starting The Engine
- 4.5 Ground Travel And Steering
- 4.6 Engaging The Deck Drive (Cutter Blades)
- 4.7 Hillside Operation
- 4.8 Parking The Mower
- 4.9 After Operation
- 4.10 Removing Clogged Material
- 4.11 Moving Mower With Engine Stopped
- 4.12 Recommendations For Mowing
- 4.13 Adjusting Cutting Height
- 4.14 Adjusting The Steering Levers
- 4.15 Adjusting The Height Adjust Pedal
- 4.16 Towing (Optional Hitch Accessory)
- TROUBLESHOOTING CUTTING CONDITIONS
- ADJUSTMENTS
- MAINTENANCE
- ILLUSTRATED PARTS LIST
- 8.1 Scag Approved Attachments And Accessories
- ELECTRICAL SCHEMATIC (KOHLER 31HP - EFI)
- REPLACEMENT DECALS AND INFORMATION PLATES
- ELECTRICAL SYSTEM (31HP-EFI KOHLER)
- BDP-16A HYDRAULIC PUMP ASSEMBLY WITH COOLING FAN
- FUEL AND HYDRAULIC SYSTEM - KOHLER 31EFI
- BRAKE AND STEERING COMPONENTS
- DECK DRIVE COMPONENTS
- STT ROLL-OVER PROTECTION SYSTEM - WITH SUSPENSION SEAT
- SHEET METAL COMPONENTS
- CUTTER DECK CONTROLS
- 61V & 72VS CUTTER DECKS
- NOTES
- LIMITED WARRANTY - COMMERCIAL EQUIPMENT
22
R
Section 5
CONDITION CAUSE CURE
SCALPING - BLADES HITTING
DIRT OR CUTTING VERY CLOSE
TO THE GROUND
Width of Deck
SGB022
Low tire pressures Check and adjust pressures
Ground speed too fast Slow speed to adjust for conditions
Cutting too low
May need to reduce ground speed, raise
cutting height, change direction of cut,
and/or change pitch and level
Rough terrain
May need to reduce ground speed, raise
cutting height, and/or change direction
of cut
Ground speed too fast Slow speed to adjust for conditions
Wet grass Cut grass after it has dried out
STEP CUT - RIDGE IN CENTER
OF CUTTING PATH
Width of Deck
SGB024
Blades not mounted evenly Adjust pitch and level
Bent blade Replace blade
Internal spindle failure See your authorized SCAG dealer
Mounting of spindle incorrect See your authorized SCAG dealer
SLOPE CUT - SLOPING RIDGES
ACROSS WIDTH OF CUTTING
PATH
Width of Deck
SGB025
Bent spindle mounting area See your authorized SCAG dealer
Internal spindle failure See your authorized SCAG dealer
Bent deck housing See your authorized SCAG dealer
TROUBLESHOOTING CUTTING CONDITIONS (CONT'D)