User's Manual
Table Of Contents
- STT-31EFI Operators Manual 03251
- GENERAL INFORMATION
- SAFETY INFORMATION
- SPECIFICATIONS
- OPERATING INSTRUCTIONS
- 4.1 Controls And Instrument Identification
- 4.2 Safety Interlock System
- 4.3 Initial Run-In Procedures
- 4.4 Starting The Engine
- 4.5 Ground Travel And Steering
- 4.6 Engaging The Deck Drive (Cutter Blades)
- 4.7 Hillside Operation
- 4.8 Parking The Mower
- 4.9 After Operation
- 4.10 Removing Clogged Material
- 4.11 Moving Mower With Engine Stopped
- 4.12 Recommendations For Mowing
- 4.13 Adjusting Cutting Height
- 4.14 Adjusting The Steering Levers
- 4.15 Adjusting The Height Adjust Pedal
- 4.16 Towing (Optional Hitch Accessory)
- TROUBLESHOOTING CUTTING CONDITIONS
- ADJUSTMENTS
- MAINTENANCE
- ILLUSTRATED PARTS LIST
- 8.1 Scag Approved Attachments And Accessories
- ELECTRICAL SCHEMATIC (KOHLER 31HP - EFI)
- REPLACEMENT DECALS AND INFORMATION PLATES
- ELECTRICAL SYSTEM (31HP-EFI KOHLER)
- BDP-16A HYDRAULIC PUMP ASSEMBLY WITH COOLING FAN
- FUEL AND HYDRAULIC SYSTEM - KOHLER 31EFI
- BRAKE AND STEERING COMPONENTS
- DECK DRIVE COMPONENTS
- STT ROLL-OVER PROTECTION SYSTEM - WITH SUSPENSION SEAT
- SHEET METAL COMPONENTS
- CUTTER DECK CONTROLS
- 61V & 72VS CUTTER DECKS
- NOTES
- LIMITED WARRANTY - COMMERCIAL EQUIPMENT
29
R
Section 6
Slot “A” Hole 1 Hole 2 Hole 3
Height (inches) 3” 3-1/2” 4”
Custom-Cut Baffle Adjustment
Mounting Slot Mounting Hardware Location
1
2
3
A
1
2
3
A
3-Position Custom-Cut Baffle AdjustmentFigure 6-9.
1
2
3
4
A
B
1
2
3
4
A
B
Custom-Cut Baffle Adjustment
Mounting Slot Selected Mounting Hardware Location
Slot “A” Hole 1 Hole 2 Hole 3 Hole 4
Height (inches) 3-3/4” 4-1/4” 4-3/4” 5-1/4”
Slot “B” Hole 2 Hole 3 Hole 4
Height (inches) 3-1/2” 4” 4-1/2”
7-Position Custom-Cut Baffle AdjustmentFigure 6-10.