User manual

The LC display
Memory icon Date
Battery icon Time
Systolic blood pressure
WHO indicator
Diastolic blood pressure
Heart rate per minute
Heartbeat icon
6
Troubleshooting and remedies
Possible errors which can occur during a measurement are listed in the table below.
Message
Error description
Correction
Pressure is not build up in the
cuff. Cuff not applied tightly
enough or leaky.
Apply cuff again and measure again.
Consult customer service if necessary
Pressure is built up very quickly
at the sensor. The cuff is too
tight or the bubble sticks.
Apply cuff again and measure again.
Consult customer service if necessary
Pump defective or pumping
error
Contact customer service
The pressure can not be
measured due to signal noise.
Please take the measurement on the left
upper arm. Make sure of the correct seat
of the cuff. Repeat measurement.
The pumping pressure is higher
than 300mmHg.
Contact customer service
or no display
Low batteries.
Please check and replace the batteries if
necessary. Do not use Ni-Cd or NiMH
rechargeable batteries
From many years of experience we know that most faults are the consequence of wrong
use. The most frequent causes of faults are excessive movement during the measurement,
11