User Guide

- 18 -
www.SCEPTRE.com
SCEPTRE X40 HDTV User Manual
3. Turn on the X40 LCD HDTV and your set-top box.
4. Use the remote control’s source button or the source button on the TV to switch to HDMI.
Please Note :
• Please reference the set-top box’s manual, to make sure the set-top box is
configured to output correctly to the TV.
• Sceptre’s X40 LCD HDTV supports SONY’s universal remote code.
Please look up SONY’s codes in your universal remote’s hand book.
Connectin
ConnectinConnectin
Connecting to a PC with VGA and 3.5 mm minijack …
g to a PC with VGA and 3.5 mm minijack …g to a PC with VGA and 3.5 mm minijack …
g to a PC with VGA and 3.5 mm minijack …
1. Make sure the power of X40 LCD HDTV and your PC is turned off.
2. Obtain a 15-pin D-Sub VGA cable; connect to the VGA output of your PC and the
other end to the VGA port on the back of your X40 LCD HDTV.
3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and the other end
to the VGA Stereo Input port.
4. Turn on the power of the X40 LCD HDTV and your PC.
5. Use the remote control’s source button or the source button on the TV to switch to
VGA.
6. Change your PC resolution to 1920x1080 at 60hz refresh rate.
7. Press MENU to use the OSD’s SETUP option.
8. Under the SETUP option select PC function.
9. Under PC function use AUTO ADJUST to adjust the screen.
Please Note :
• For the best results, please set your PC resolution to 1920x1080 at 60
Hz. Please refer to the PC or graphic card’s manual for further
instructions on how to set your resolution and refresh rate.
• Please refer to your PC manual for video output requirements of the
video card.
• The VGA port of the TV features a power saving mode which will
automatically turn off the TV, if there’s no signal provided for more than
5 minutes.