User Manual

Do not open. No serviceable parts inside. Provided with integral
protection against overloads. Bonding between conduit connections
is not automatic and must be provided as part of the installation.
Read manual before installing or using.
Do not cover or obstruct ventilation open
ings.
Do not mount in zero-clearance compartment – overheating may
result.
Do not expose to rain or spray. This inverter is designed f
or marine
applications only when additional drip protection is installed in
certain orientations. See “Approved Mounting Orientations” on the
Installation Guide for more information.
Use GFCIs only as specified in the manuals supplied
with unit. Other
types may fail to operate when connected to this unit.
Do not connect AC OUT to any other
source of power. Damage to
unit may occur.
For AC IN and AC OUT, use wires suitable for at least 75°C.
vi Freedom Xi Owners Guide
NOTES:
1. Follow these instructions and
those published by the battery
manufacturer and the manufacturer of any equipment you intend to use
in the vicinity of the battery. Review cautionary markings on these
products and on the engine.
2. Freedom Xi inverter products are desig
ned for deep cycle lead-acid
batteries only. The Freedom Xi does not support lithium-ion batteries.
3. Do not use transformerless battery
chargers in conjunction with the
inverter due to overheating.
CAUTION
ELECTRICAL SHOCK AND FIRE HAZARD
Failure to follow these instructions can result in minor or moderate
injury.
CAUTION
PHYSICAL INJURY HAZARD
This Freedom Xi Sine Wave Inverter is not intended for use by persons
(including children) with reduced physical, sensory, or mental
capabilities or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance.
Failure to follow these instructions can result in minor or moderate injury.
Freedom XI Owners Guide.book Page vi Friday, September 18, 2015 2:57 PM