Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 113
Parameters described in this page can be accessed by:
rUn [Drive Running]
[No] (nO)
g
Assignment of the stop command.
Visible only if [2/3 wire control] (tCC) is set to [3 wire] (3C).
LI1
Cd00
OL01
...
OL10
[LI1] (LI1): Logical input LI1 if not in [I/O profile] (IO)
[Cd00] (Cd00): In [I/O profile] (IO), can be switched with possible logic inputs
[OL01] (OL01): Function blocks: Logical Output 01
...
[OL10] (OL10): Function blocks: Logical Output 10
Frd [Forward]
[LI1] (LI1)
LI1
Cd00
OL01
...
OL10
Assignment of the forward direction command.
[LI1] (LI1): Logical input LI1 if not in [I/O profile] (IO)
[Cd00] (Cd00): In [I/O profile] (IO), can be switched with possible logic inputs
[OL01] (OL01): Function blocks: Logical Output 01
...
[OL10] (OL10): Function blocks: Logical Output 10
rrS [Reverse assign.]
[LI2] (LI2)
nO
LI1
...
Assignment of the reverse direction command.
[No] (nO): Not assigned
[LI1] (LI1): Logical input LI1
[...] (...): See the assignment conditions on page 138
Code Name / Description Adjustment range Factory setting
DRI- > CONF > FULL > I_O-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com