Installation manual

Configuration Mode (ConF)
132 S1A28692 03/2010
Reference channel for [Not separ.] (SIM), [Separate] (SEP) and [I/O profile] (IO) configurations, PID not configured
Fr1, SA2, SA3, dA2, dA3, MA2, MA3:
• Terminals, graphic display terminal, integrated Modbus, integrated CANopen®, communication card
Fr1b, for SEP and IO:
• Terminals, graphic display terminal, integrated Modbus, integrated CANopen®, communication card
Fr1b, for SIM:
• Terminals, only accessible if Fr1 = terminals
Fr2:
• Terminals, graphic display terminal, integrated Modbus, integrated CANopen®, communication card, and
+/- speed
Note: [Ref.1B channel] (Fr1b) and [Ref 1B switching] (rCb) must be configured in the
[APPLICATION FUNCT.] (Fun-) menu.
H/>
72H
279/
:52
H2/
2H%
279
;-%
;-&
@-%
@-&
8-%
8-&
2H$
2H$>
+/- speed around a
reference
Preset
speeds
Jog
operation
PID not assigned
Graphic display
terminal
Forced local
Ramps
Parameter:
The black square represents
the factory setting assignment
Key:
Channel 1
Channel
[Ref 1B switching]
[Ref.1 channel]
[Ref.1B channel]
[Summing ref. 2]
[Summing ref. 3]
[Subtract. ref. 2]
[Subtract. ref. 3]
[Multiplier ref. 2]
[Low speed]
[Multiplier ref. 3]
[PID REGULATOR]
AI1
[Ref.2 channel]
[Ref. 2 switching]
(FRA + SA2 + SA3 - dA2 - dA3) x MA2 x MA3
(SP1)
SP2
SP16
LI
LCC
FRA
nO
[High
speed]
nO
nO
nO
nO
FrH
rFr
AI2
AI3
HSP
LSP
ACC DEC
AC2 DE2
LI
nO
0V
Note: Forced local is not
active in [I/O profile].
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com