Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 141
Parameters described in this page can be accessed by:
COP [Copy channel 1 <> 2]
[No] (nO)
DANGER
UNINTENDED EQUIPMENT OPERATION
Copying the command and/or reference can change the direction of rotation.
Check that this is safe.
Failure to follow these instructions will result in death or serious injury.
nO
SP
Cd
ALL
Can be used to copy the current reference and/or the command by means of switching, in order to avoid speed surges, for
example.
If [Profile] (CHCF) page 139
is set to [Not separ.] (SIM) or [Separate] (SEP), copying will only be possible from channel 1
to channel 2.
If [Profile] (CHCF) is set to [I/O profile] (IO), copying will be possible in both directions.
A reference or a command cannot be copied to a channel on the terminals.
The reference copied is [Frequency ref.] (FrH) (before ramp) unless the destination channel reference is set via +/- speed. In
this case, the reference copied is [Output frequency] (rFr) (after ramp).
[No] (nO): No copy
[Reference] (SP): Copy reference
[Command] (Cd): Copy command
[Cmd + ref.] (ALL): Copy command and reference
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
To change the assignment of this parameter, press the ENT key for 2 s.
Code Name / Description Adjustment range Factory setting
2 s
2 s
DRI- > CONF > FULL > CTL-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com