Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 143
Parameters described in this page can be accessed by:
Function Block Management
Code Name / Description Adjustment range Factory setting
FULL [FULL] (continued)
FbM- [FUNCTION BLOCKS]
MFb- [MONIT. FUN. BLOCKS]
Note: This section shows only what is possible to do with local or remote display on the drive. For advanced configuration using
PC software, please refer to the dedicated Function blocks manual.
FbSt [FB Status]
IdLE
CHEC
StOP
InIt
rUn
Err
[Idle] (IdLE): No binary file in the target, the FB is waiting for a download
[Check] (CHEC): Check the program downloaded
[Stop] (StOP): The Function blocks application is stopped
[Init] (InIt): Check coherency between ATVLogic program and Function blocks parameters
[Run] (rUn): The Function blocks application is running
[Error] (Err): An internal error has been detected. The Function blocks application is in fault state mode.
FbFt [FB Fault]
nO
Int
bIn
InP
PAr
CAL
tOAU
tOPP
AdL
In
[No] (nO): No detected fault
[Internal] (Int): Internal detected error
[Binary file] (bIn): Binary file corrupted
[Intern Para.] (InP): Internal parameter detected error
[Para. RW] (PAr): Parameter access detected error
[Calculation] (CAL): Calculation detected error
[TO AUX] (tOAU): TimeOut AUX task
[TO synch] (tOPP): TimeOut in PRE/POST task
[Bad ADLC] (AdL): ADLC with bad parameter
[Input assig.] (In): Input not configured
FbI- [FB IDENTIFICATION]
bUEr [Cust. program version]
0 to 255 -
g
Program user version.
bnS [Program size]
0 to 65,535 -
g
Program file size.
bnU [Prg. format version]
0 to 255 -
Binary format version of the drive.
CtU [Catalog version]
0 to 65,535 -
Catalog version of the drive.
FbM- [FUNCTION BLOCKS] (continued)
FbCd
T
[FB Command]
Allows to start and stop the function blocks manually.
StOP
Strt
[FB Command] (FbCd) is forced to [Stop] (StOP) if there is no valid function blocks application in the drive memory.
[FB Command] (FbCd) is set to [Start] (Strt) when the function blocks application switch to Run according to
[FB start mode] (FbrM) configuration.
Note: As soon as the function blocks are started, the drive is considered as in running state and the modification of configuration
parameters is no longer possible.
[Stop] (StOP): Function blocks application Stop command
[Start] (Strt): Function blocks application Start command
DRI- > CONF > FULL > FBM- > MFB-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com