Installation manual

Configuration Mode (ConF)
146 S1A28692 03/2010
Parameters described in this page can be accessed by:
(1) If a graphic display terminal is not in use, values greater than 9,999 will be displayed on the 4-digit display with a period
mark after the thousand digit, for example, 15.65 for 15,650.
FbM- [FUNCTION BLOCKS] (continued)
FbP- [FB PARAMETERS]
Internal parameters available for the user program.
M001 [ ]
0 to 65,535 0
(1)
T
M001 Parameter saved in EEprom.
M002 [ ]
0 to 65,535 0
(1)
T
M002 Parameter saved in EEprom
M003 [ ]
0 to 65,535 0
(1)
T
M003 Parameter saved in EEprom
M004 [ ]
0 to 65,535 0
(1)
T
M004 Parameter saved in EEprom
M005 [ ]
0 to 65,535 0
(1)
T
M005 Parameter written in RAM
M006 [ ]
0 to 65,535 0
(1)
T
M006 Parameter written in RAM
M007 [ ]
0 to 65,535 0
(1)
T
M007 Parameter written in RAM
M008 [ ]
0 to 65,535 0
(1)
T
M008 Parameter written in RAM
Code Name / Description Adjustment range Factory setting
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
T
Parameter that can be modified during operation or when stopped.
To change the assignment of this parameter, press the ENT key for 2 s.
2 s
DRI- > CONF > FULL > FBM- > FBP-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com