Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 149
It is only possible to assign one input to several functions at [Advanced] (AdU) and [Expert] (EPr) levels.
Before assigning a command, reference or function to an input or output, the user must check that this input
or output has not already been assigned and that another input or output has not been assigned to an
incompatible function.
The drive factory setting or macro configurations automatically configure functions, which may help to
prevent other functions being assigned.
In some case, it is necessary to unconfigure one or more functions in order to be able to enable
another. Check the compatibility table below.
Stop functions have priority over run commands.
Speed references via logic command have priority over analog references.
Note: This compatibility table does not affect commands that can be assigned to the keys of the graphic
display terminal (see page 24
).
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com