Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 175
Parameters described in this page can be accessed by:
(1) The parameter can also be accessed in the [SETTINGS] (SEt-) menu.
ASt [Angle setting type]
[PSIO align.] (PSIO)
g
Mode for measuring the phase-shift angle. Visible only if [Motor control type] (Ctt) is set to [Sync. mot.] (SYn ).
[PSI align] (PSI) and [PSIO align] (PSIO) are working for all type of synchronous motors. [SPM align] (SPMA) and
[IPM align] (IPMA) increase performances depending on the type of synchronous motor.
IPMA
SPMA
PSI
PSIO
nO
[IPM align] (IPMA): Alignment for IPM motor. Alignment mode for Interior-buried Permanent Magnet motor (usually, this kind
of motor has a high saliency level). It uses high frequency injection, which is less noisy than standard alignment mode.
[SPM align] (SPMA): Alignment for SPM motor. Mode for Surface-mounted Permanent Magnet motor (usually, this kind of
motor has a medium or low saliency level). It uses high frequency injection, which is less noisy than standard alignment mode.
[PSI align] (PSI): Pulse signal injection. Standard alignment mode by pulse signal injection.
[PSIO align] (PSIO): Pulse signal injection - Optimized. Standard optimized alignment mode by pulse signal injection. The
phase-shift angle measurement time is reduced after the first run order or tune operation, even if the drive has been turned off.
[No align] (nO): No alignment
Code Name / Description Adjustment range Factory setting
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
T
Parameter that can be modified during operation or when stopped.
To change the assignment of this parameter, press the ENT key for 2 s.
2 s
DRI- > CONF > FULL > FUN- > FLI-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com