Installation manual

Configuration Mode (ConF)
190 S1A28692 03/2010
Parameters described in this page can be accessed by:
Code Name / Description Adjustment range Factory setting
FUn- [APPLICATION FUNCT.] (continued)
HSH- [HIGH SPEED HOISTING]
Note: This function cannot be used with certain other functions. Follow the instructions on page 148.
HSO [High speed hoisting]
[No] (nO)
nO
SSO
CSO
[No] (nO): Function inactive
[Speed ref] (SSO): Speed reference mode
[I Limit] (CSO): Current limitation mode
COF [Motor speed coeff.]
0 to 100% 100%
g
T
Speed reduction coefficient calculated by the drive for Ascending direction.
This parameter can be accessed if [High speed hoisting] (HSO) is set to [Speed ref] (SSO).
COr [Gen. speed coeff]
0 to 100% 50%
g
T
Speed reduction coefficient calculated by the drive for Descending direction.
This parameter can be accessed if [High speed hoisting] (HSO) is not set to [No] (nO).
tOS [Load measuring tm.]
0.1 s to 65 s 0.5 s
g
T
Duration of speed step for measurement.
This parameter can be accessed if [High speed hoisting] (HSO) is not set to [No] (nO).
OSP [Measurement spd]
0 to [Rated motor freq.] (FrS) 40 Hz
g
T
Speed stabilized for measurement.
This parameter can be accessed if [High speed hoisting] (HSO) is not set to [No] (nO).
CLO [High speed I Limit]
0 to 1.5 In (1) In (1)
g
T
Current limitation at high speed.
This parameter can be accessed if [High speed hoisting] (HSO) is set to [I Limit] (CSO).
Note: If the setting is less than 0.25 In, the drive may lock in [Output Phase Loss] (OPL) fault mode if this has been enabled
(see page 238
).
SCL [I Limit. frequency]
0 to 599 Hz according to rating 40 Hz
g
T
Frequency threshold, above which the high-speed limitation current is active.
This parameter can be accessed if [High speed hoisting] (HSO) is set to [I Limit] (CSO).
rSd [Rope slack config.]
[No] (nO)
g
Rope slack function.
This parameter can be accessed if [High speed hoisting] (HSO) is not set to [No] (nO).
nO
drI
PES
[No] (nO): Function inactive
[Drive estim.] (drI): Measurement of the load by estimating the torque generated by the drive
[Ext. sensor] (PES): Measurement of the load using a weight sensor, can only be assigned if [Weight sensor ass.] (PES)
page 185
is not [No] (nO)
DRI- > CONF > FULL > FUN- > HSH-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com