Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 203
Parameters described in this page can be accessed by:
(1) The parameter can also be accessed in the [SETTINGS] (SEt-) menu.
tLC [Analog limit. act.]
[Yes] (YES)
g
This parameter cannot be accessed if [Torque limit. activ.] (tLA) is set to [No] (nO).
Identical to [Torque limit. activ.] (tLA) page 202
.
If the assigned input or bit is at 0:
The limitation is specified by the [Motoring torque lim] (tLIM) and [Gen. torque lim.] (tLIG) parameters if
[Torque limit. activ.] (tL A) is not [No] (nO).
No limitation if [Torque limit. activ.] (tLA) is set to [No] (nO).
If the assigned input or bit is at 1:
The limitation depends on the input assigned by [Torque ref. assign.] (tAA).
Note: If [Torque limitation] (tLA) and [Torque ref. assign.] (tAA) are enabled at the same time, the lowest value will be
taken into account.
Code Name / Description Adjustment range Factory setting
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
T
Parameter that can be modified during operation or when stopped.
DRI- > CONF > FULL > FUN- > TOL-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com