Installation manual

Configuration Mode (ConF)
216 S1A28692 03/2010
Parameters described in this page can be accessed by:
Note: We recommend that a parameter set switching test is carried out while stopped and a check is made to
verify that it has been performed correctly.
Some parameters are interdependent and in this case may be restricted at the time of switching.
Interdependencies between parameters must be respected, even between different sets.
Example: The highest [Low speed] (LSP) must be below the lowest [High speed] (HSP).
MLP- [PARAM. SET SWITCHING] (continued)
PS3- [SET 3]
g
T
S301
...
S315
This parameter can be accessed if [3 parameter sets] (CHA2) is not [No] (nO) and if at least 1 parameter has been selected
in [PARAMETER SELECTION].
Identical to [SET 1] (PS1-) page 215
.
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
T
Parameter that can be modified during operation or when stopped.
Code Name / Description Adjustment range Factory setting
DRI- > CONF > FULL > FUN- > MLP- > PS3-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com