Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 221
Parameters described in this page can be accessed by:
AUTO TUNING BY LOGIC INPUT
Code Name / Description Adjustment range Factory setting
FUn- [APPLICATION FUNCT.] (continued)
tnL- [AUTO TUNING BY LI]
tUL [Auto-tune assign.]
[No] (nO)
nO
LI1
...
Auto-tuning is performed when the assigned input or bit changes to 1.
Note: Auto-tuning causes the motor to start up.
[No] (nO): Not assigned
[LI1] (LI1): Logical input LI1
[...] (...): See the assignment conditions on page 138
DRI- > CONF > FULL > FUN- > TNL-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com