Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 233
Parameters described in this page can be accessed by:
rPA [Product reset assig.]
[No] (nO)
g
DANGER
UNINTENDED EQUIPMENT OPERATION
This configuration enables to reset the drive.
Check this action will not endanger personnel or equipment in any way.
Failure to follow these instructions will result in death or serious injury.
nO
LI1
...
LI6
LAI1
LAI2
OL01
...
OL10
This parameter can only be modified if [3.1 ACCESS LEVEL] (LAC) is set to [Expert] (EPr) mode.
Drive reinitialization via logic input. Can be used to reset all detected faults without having to disconnect the drive from the power
supply. The drive is reinitialized on a rising edge (change from 0 to 1) of the assigned input. The drive can only be reinitialized
when locked.
To assign reinitialization, press and hold down the ENT key for 2 s.
[No] (nO):
Function inactive
[LI1] (LI1): Logical input LI1
...
[LI6] (LI6): Logical input LI6
[LAI1] (LAI1): Logical input AI1
[LAI2] (LAI2): Logical input AI2
[OL01] (OL01): Function blocks: Logical Output 01
...
[OL10] (OL10): Function blocks: Logical Output 10
rP [Product reset]
[No] (nO)
g
DANGER
UNINTENDED EQUIPMENT OPERATION
You are going to reset the drive.
Check this action will not endanger personnel or equipment in any way.
Failure to follow these instructions will result in death or serious injury.
nO
YES
This parameter can only be accessed if [3.1 ACCESS LEVEL] (LAC) is set to [Expert] (EPr) mode.
Drive reinitialization. Can be used to reset all detected faults without having to disconnect the drive from the power supply.
[No] (nO): Function inactive
[Yes] (YES): Reinitialization. Press and hold down the ENT key for 2 s. The parameter changes back to [No] (nO)
automatically as soon as the operation is complete. The drive can only be reinitialized when locked.
Code Name / Description Adjustment range Factory setting
DRI- > CONF > FULL > FLT- > RST-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com