Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 235
Parameters described in this page can be accessed by:
(1) In corresponds to the rated drive current indicated in the Installation manual and on the drive nameplate.
FqL [Pulse warning thd.]
0 to 20,000 Hz 0 Hz
g
Frequency level.
Visible if [Frequency meter] (FqF) is not [No] (nO).
FLt- [FAULT MANAGEMENT] (continued)
FLr- [CATCH ON THE FLY]
Note: This function cannot be used with certain other functions. Follow the instructions on page 147.
FLr [Catch on the fly]
[No] (nO)
nO
YES
Used to enable a smooth restart if the run command is maintained after the following events:
- Loss of line supply or disconnection.
- Clearance of current detected fault or automatic restart.
- Freewheel stop.
The speed given by the drive resumes from the estimated speed of the motor at the time of the restart, then follows the ramp to
the reference speed.
This function requires 2-wire level control.
When the function is operational, it activates at each run command, resulting in a slight delay of the current (0.5 s max).
[Catch on the fly] (FLr) is forced to [No] (nO) if brake logic control [Brake assignment] (bLC) is assigned (page 179
) or
if [Auto DC injection] (AdC) is set to [Continuous] (Ct) page 161
.
[No] (nO): Function inactive
[Yes] (YES): Function active
Code Name / Description Adjustment range Factory setting
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
T
Parameter that can be modified during operation or when stopped.
To change the assignment of this parameter, press the ENT key for 2 s.
2 s
DRI- > CONF > FULL > FUN- > FLT- > ALS-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com