Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 249
Parameters described in this page can be accessed by:
(1) Because, in this case, the detected fault does not trigger a stop, it is recommended to assign a relay or logic output to
its indication.
FLt- [FAULT MANAGEMENT] (continued)
tnF- [AUTO TUNING FAULT]
tnL [Autotune fault mgt]
[Freewheel] (YES)
nO
YES
[Ignore] (nO): Detected fault ignored
[Freewheel] (YES): Freewheel stop
Code Name / Description Adjustment range Factory setting
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
T
Parameter that can be modified during operation or when stopped.
DRI- > CONF > FULL > FLT- > TNF-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com