Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 252
Parameters described in this page can be accessed by:
UdL [Underload Managmt.]
[Freewheel] (YES)
g
Behavior on switching to underload detection.
nO
YES
rMP
FSt
[Ignore] (nO): Detected fault ignored
[Freewheel] (YES): Freewheel stop
[Ramp stop] (rMP): Stop on ramp
[Fast stop] (FSt): Fast stop
FtU [Underload T.B. Rest.]
0 to 6 min 0 min
g
T
This parameter cannot be accessed if [Underload Mangmt.] (UdL) is set to [Ignore] (nO).
Minimum time permitted between an underload being detected and any automatic restart.
In order to allow an automatic restart, the value of [Max. restart time] (tAr) page 234
must exceed this parameter by at least
one minute.
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
T
Parameter that can be modified during operation or when stopped.
Code Name / Description Adjustment range Factory setting
DRI- > CONF > FULL > FLT- > ULD-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com