Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 259
Parameters described in this page can be accessed by:
COM- [COMMUNICATION] (continued)
Cbd- [COMMUNICATION CARD]
See the specific documentation for the card used.
LCF- [FORCED LOCAL]
FLO [Forced local assign.]
[No] (nO)
WARNING
LOSS OF CONTROL
If the equipment switches to forced local mode, virtual input used in the current configuration will remain fixed
at the last value transmitted.
Do not use the virtual input and forced local mode in the same configuration.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
nO
LI1
...
LI6
LAI1
LAI2
OL01
...
OL10
Forced local assignment.
Forced local mode is active when the input is at state 1.
[Forced local assign.] (FLO) is forced to [No] (nO) if [Profile] (CHCF) is set to [I/O profile] (IO) page 139
.
[No] (nO): Function inactive
[LI1] (LI1): Logical input LI1
...
[LI6] (LI6): Logical input LI6
[LAI1] (LAI1): Logical input AI1
[LAI2] (LAI2): Logical input AI2
[OL01] (OL01): Function blocks: Logical Output 01
...
[OL10] (OL10): Function blocks: Logical Output 10
FLOC [Forced local Ref.]
[No] (nO)
nO
AI1
AI2
AI3
LCC
PI
OA01
...
OA10
Forced local reference source assignment.
[No] (nO): Not assigned (control via the terminals with zero reference)
[AI1] (AI1): Analog input
[AI2] (AI2): Analog input
[AI3] (AI3): Analog input
[HMI] (LCC): Assignment of the reference and command to the graphic display terminal or remote display terminal.
Reference: [HMI Frequency ref.] (LFr) page 44
.
Command: RUN/STOP/FWD/REV keys.
[RP] (PI): Pulse input
[OA01] (OA01): Function blocks: Analog Output 01
...
[OA10] (OA10): Function blocks: Analog Output 10
FLOt [Time-out forc. local]
0.1 to 30 s 10.0 s
g
0.1 to 30 s.
This parameter can be accessed if [Forced local assign.] (FLO) is not set to [No] (nO).
Time delay before communication monitoring is resumed on leaving forced local mode.
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
Code Name / Description Adjustment range Factory setting
DRI- > CONF > FULL > COM- > CBD- > LCF-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com