Installation manual

Interface (ItF)
266 S1A28692 03/2010
Parameters described in this page can be accessed by:
Code Name / Description
MCF- [3.3 MONITORING CONFIG]
Code Name / Description
PbS- [PARAM. BAR SELECT]
[AI1]
[AI2]
[AI3]
[AO1]
[ETA state world]
[Alarm groups]
[Frequency ref.]
[Output frequency]
[Motor current]
[Motor speed]
[Motor voltage]
[Motor power]
[Motor torque]
[Mains voltage]
[Motor thermal state]
[Drv. thermal state]
[Consumption]
[Run time]
[Power on time]
[IGBT alarm counter]
[Min. freq time]
[PID reference]
[PID feedback]
[PID error]
[PID Output]
[Config. active]
[Utilised param. set]
in V
in V
in mA
in V
in Hz: parameter displayed in factory configuration
in Hz
in A: parameter displayed in factory configuration
in rpm
in V
in W
as a %
in V
as a %
as a %
in Wh or kWh depending on drive rating
in hours (length of time the motor has been switched on)
in hours (length of time the drive has been switched on)
in seconds (total time of IGBT overheating alarms)
in seconds
as a %
as a %
as a %
in Hz
CNF0, 1 or 2 (see page 217
)
SET1, 2 or 3 (see page 215
)
Select the parameter using ENT (a then appears next to the parameter). Parameter(s) can also be
deselected using ENT.
1 or 2 parameters can be selected.
Example:
PARAM. BAR SELECT
MONITORING
- - - - - - - - -
- - - - - - - - -
- - - - - - - - -
- - - - - - - - -
ITF- > MCF-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com