Installation manual

Interface (ItF)
S1A28692 03/2010 273
Parameter access
Note: The protected parameters are no longer accessible and are not, therefore, displayed for the selected
channels.
Selection to display all
parameters or only the
active parameters.
Press ESC to exit this
screen.
You remain exclusively
in the [1 DRIVE MENU]
menu. All menus are
selected by default.
Press ENT to deselect a
menu.
Press ENT to reselect a
menu.
Note: The protected channel (or channels) must be
selected, as a protected parameter on a selected channel
remains accessible on the channels that are not selected.
In these screens, all
parameters in the
[1 DRIVE MENU] menu
can be protected and are
displayed for selection,
except for the Expert
parameters.
Press the All key to
select all the parameters.
Press the All key again to
deselect all the
parameters.
RDY Term 0.0 Hz 0.0 A
PARAMETER ACCESS
PROTECTION
VISIBILITY
Code << >> Quick
RDY Term 0.0 Hz 0.0 A
VISIBILITY
PARAMETERS
MENUS
Code Quick
ENT
ENT
RDY Term 0.0 Hz 0.0 A
PARAMETERS
Active
All
Quick
ENT
MENUS
1 DRIVE MENU
1.1 SPEED REFERENCE
1.2 MONITORING
1.3 CONFIGURATION
RDY Term 0.0 Hz 0.0 A
PROTECTION
PROTECTED CHANNELS
PROTECTED PARAMS
Code Quick
ENT
RDY Term 0.0 Hz 0.0 A
PROTECTED CHANNELS
HMI
PC TOOL
MODBUS
CANopen
COM. CARD
Code Quick
ENT
ENT
PROTECTED PARAMS
1 DRIVE MENU
1.1 SPEED REFERENCE
1.2 MONITORING
1.3 CONFIGURATION
All None
PROTECTED PARAMS
1.3 CONFIGURATION
MY MENU
FACTORY SETTINGS
Macro configuration
FULL
All None
ENT
PROTECTED PARAMS
APPLICATION FUNCT.
REF. OPERATIONS
RAMP
STOP CONFIGURATION
AUTO DC INJECTION
JOG
PROTECTED PARAMS
JOG
JOG
Jog frequency
Jog delay
ENT
No selections can be made in this
screen if there are no parameters.
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com