Installation manual

Open / Save as (trA)
S1A28692 03/2010 279
DOWNLOAD GROUP
[None]: No parameters
[All]: All parameters in all menus
[Drive configuration]: The entire [1 DRIVE MENU] without
[COMMUNICATION]
[Motor parameters]: [Rated motor volt.] (UnS) In the [MOTOR CONTROL] (drC-) menu
[Rated motor freq.] (FrS)
[PSI align curr. max] (NCr)
[Rated motor speed] (nSP)
[Motor 1 Cosinus phi] (COS)
[Rated motor power] (nPr)
[Motor param choice] (MPC)
[Tune selection] (StUn)
[Mot. therm. current] (ItH)
[IR compensation] (UFr)
[Slip compensation] (SLP)
[Cust stator resist.] (rSA)
[Lfw] (LFA)
[Cust. rotor t const.] (trA)
[Nominal I sync.] (nCrS)
[Nom motor spdsync] (n SPS)
[Pole pairs] (PPnS)
[Syn. EMF constant] (PHS)
[Autotune L d-axis] (LdS)
[Autotune L q-axis] (LqS)
[N
ominal freq sync.] (FrSS)
[Cust. stator R syn] (rSAS)
[Motor torque] (tqS)
[U1] (U1)
[F1] (F1)
[U2] (U2)
[F2] (F2)
[U3] (U3)
[F3] (F3)
[U4] (U4)
[F4] (F4)
[U5] (U5)
[F5] (F5)
The motor parameters that can be accessed in [Expert] (EPr)
mode, page 243
.
[Mot. therm. current] (ItH) In the [SETTINGS] (SEt-) menu
[Communication] : All the parameters in the [COMMUNICATION] menu
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com