Installation manual

S1A28692 03/2010 283
Multipoint Screen
9
Multipoint Screen
Multipoint Screen
Communication is possible between a graphic display terminal and a number of drives connected on the same
bus. The addresses of the drives must be configured in advance in the [COMMUNICATION] (COM-) menu
using the [Modbus Address] (Add) parameter, page 257.
When a number of drives are connected to the same graphic display terminal, it automatically displays the
following screens:
In multipoint mode, the command channel is not displayed. From left to right, the state, then the 2 selected
parameters, and finally the drive address appear.
All menus can be accessed in multipoint mode. Only drive control via the graphic display terminal is not
authorized, apart from the Stop key, which locks all the drives.
If there is a trip on a drive, this drive is displayed.
Selection of drives for multipoint dialog (select each address and
check the box by pressing ENT).
This screen only appears the first time the drive is powered up, or if
the "Cfg Add" function key on the MULTIPOINT SCREEN is pressed
(see below).
Selection of a drive for multipoint dialog.
CONNECTION IN PROGRESS
Vxxxxxx
MULTIPOINT ADDRESSES
Address 1
Address 2
Address 3
Address 4
Address 5
Address 6
ESC
MULTIPOINT SCREEN
Rdy 0 Rpm 0 A 2
RUN +952 Rpm 101 A 3
NLP +1500 Rpm 1250 A 4
Not connected 5
Rdy + 0 Rpm 0 A 6
Cfg Add
Cfg Add
RUN +952 Rpm 101 A 3
Motor speed
Motor current
HOME T/K
ESC
ENT
+952 rpm
101 A
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com