Installation manual

Overview
30 S1A28692 03/2010
Remote display terminal option
Description of the remote display terminal
This remote display terminal is a local control unit which can be mounted on the door of the wall-mounted or
floor-standing enclosure. It has a cable with connectors, which is connected to the drive serial link (see the
documentation supplied with the remote display terminal). With this remote display terminal, up and down
arrows are used for navigation rather than a jog dial.
(1) If the drive is locked by a code ([PIN code 1] (COd) page 282
), pressing the MODE key enables you to
switch from the [1.2 MONITORING] (MOn-) menu to the [1.1 SPEED REFERENCE] (rEF-) menu and
vice versa.
To activate the keys on the remote display terminal, you first have to configure [Ref.1 channel] (Fr1) =
[HMI] (LCC). For more information, see page 139.
1 Four digits display
2 MODE key (1):
Used to switch
[1.1 SPEED REFERENCE] (rEF-),
[1.2 MONITORING] (MOn-) and
[1.3 CONFIGURATION] (COnF-)
menus.
3 ESC key
Used to quit a menu/parameter or
remove the currently displayed value in
order to revert to the previous value
retained in the memory
4 RUN key
Executes the function
assuming it has been
configured
5 Navigation keys
6 ENT key
Used to save the current value or
access the selected menu/parameter
8 Key for reversing the direction of
rotation of the motor
7 STOP key
Used to stop the motor and perform a
reset
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com