Installation manual

Overview
S1A28692 03/2010 31
Structure of the parameter tables
The parameter tables contained in the descriptions of the various menus are organized as follows.
Example:
Note: The text in square brackets [ ] indicates what you will see on the graphic display terminal.
A menu followed by the mention "(continued)" appears sometimes to locate you in the structure.
Example:
In this case, the mention "(continued)" indicates that the [APPLICATION FUNCT.] submenu is above the
[PID REGULATOR] submenu in the structure.
A parameter can contain some pictograms. Each pictogram has its legend at the end of the table.
Main mictograms:
Code Name / Description Adjustment range Factory setting
PId- [PID REGULATOR]
Note: This function cannot be used with certain other functions. Follow the instructions on page 147.
PIF [PID feedback ass.]
[No] (nO)
nO
A11
A12
A13
PI
AIU2
OA01
...
OA10
[No] (nO): Not assigned
[Al1] (A11): Analog input A1
[Al2] (A12): Analog input A2
[Al3] (A13): Analog input A3
[RP] (PI): Pulse input
[AI virtual 2] (AIU2): Virtual analog input 2
[OA01] (OA01): Function blocks: Analog Output 01
...
[OA10] (OA10): Function blocks: Analog Output 10
1. Way to access the parameters described in this page 5. Name of submenu on graphic display terminal
2. Submenu code on 4-digit 7-segment display 6. Name of parameter on graphic display terminal
3. Parameter code on 4-digit 7-segment display 7. Value of parameter on graphic display terminal
4. Parameter value on 4-digit 7-segment display
FUn- [APPLICATION FUNCT.] (continued)
PId- [PID REGULATOR]
Note: This function cannot be used with certain other functions. Follow the instructions on page 147.
DRI- > CONF > FULL > FUN-
Parameters described in this page can be accessed by:
1
3
2
4
5
6
7
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
T
Parameter that can be modified during operation or when stopped.
To change the assignment of this parameter, press the ENT key for 2 s.
2 s
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com