Installation manual

Overview
S1A28692 03/2010 33
Description of the HMI
Normal display, with no fault code displayed and no startup:
Displays the parameter selected in the [1.2 MONITORING] (MOn-) menu (default:
[Frequency ref.] (FrH)).
• InIt: Initialization sequence (only on remote display terminal)
• tUN: AutoTuning
• dCb: Injection braking
• rdY: Drive ready
• nSt: Freewheel stop control
• CLI: Current limit
• FSt: Fast stop
• FLU: Fluxing function is activated
• nLP: Control is powered on but the DC bus is not loaded
• CtL: Controlled stop
• Obr: Adapted deceleration
• SOC: Stand by output cut
• USA: Undervoltage alarm
• SS1: Safety SS1 level
• SLS: Safety SLS level
• StO: Safety STO level
In the event of a detected fault, the display will flash to notify the user accordingly. If a graphic display terminal
is connected, the name of the detected fault will be displayed.
A REF mode selected (rEF-) E Dot used to display parameter value (1/10 unit)
B MON mode selected (MOn-) F Current display is parameter value
C CONF mode selected (COnF) G Current display is parameter unit
D Dot used to display parameter value (1/100 unit)
Functions of the Display and the
Keys
1 The ESC key is used for menu
navigation (backward) and parameters
adjustment (cancel)
2 The Jog dial is used for menu
navigation (up or down) and parameters
adjustment (increase/decrease value or
element choice). It can be used as
Virtual analogic input 1 for drive
frequency reference.
3 The ENT key (push on the Jog dial) is
used for menu navigation (forward) and
parameters adjustment (validate)
88 88
A
B
C
D
F
G
E
1
3
2
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com