Installation manual

Overview
34 S1A28692 03/2010
Structure of the menus
On the 7-segment display, a dash after menu and submenu codes is used to differentiate them from
parameter codes.
Example: [APPLICATION FUNCT.] (FUn-) menu, [Acceleration] (ACC) parameter
Selection of multiple assignments for one parameter
Example: List of group 1 alarms in [INPUTS / OUTPUTS CFG] (I_O-) menu
A number of alarms can be selected by "checking" them as follows.
The digit on the right indicates:
The same principle is used for all multiple selections.
Powering up Parameter selection
This parameter is only visible when
the drive is powered up for the first
time.
The setting can be amended
subsequently in the menu
[MOTOR CONTROL] (drC-) for
[Standard mot. freq] (bFr)
[1.1 SPEED REFERENCE] (rEF-)
[1.2 MONITORING] (MOn-)
[1.3 CONFIGURATION] (COnF)
= ENT
rEF-
MOn-
COnF
bFr
ESC
= ESC
= ENT
ESC
ENT
ESC
ESC
ENT
ENT
ESC
Inr
ESC
= ESC
01
SEt-
ACC
FFM
001
001
selected not selected
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com