Installation manual

Monitoring Mode (MOn)
S1A28692 03/2010 45
Parameters described in this page can be accessed by:
MOn- [1.2 MONITORING] (continued)
IOM- [I/O MAP]
LIA- [LOGIC INPUT CONF.]
Logic input functions.
LIA [LI1 assignment]
Read-only parameters, cannot be configured.
It displays all the functions that are assigned to the logic input in order to check for multiple assignments.
If no functions have been assigned, [No] (nO) is displayed. Use the jog dial to scroll through the functions.
The use of graphic display terminal allows to see the delay [LI1 On Delay] (L1d). Possible values are the same than in
configuration menu page 114
.
L2A
to
L6A
LA1A
LA2A
[L-- assignment]
All the logic inputs available on the drive are processed as in the example for LI1 above.
LIS1 [State of logic inputs LI1 to LI6]
Can be used to visualize the state of logic inputs LI1 to LI6 (display segment assignment: high = 1, low = 0).
Example above: LI1 and LI6 are at 1; LI2 to LI5 are at 0.
LIS2 [State of Safe Torque Off]
Can be used to visualize the state of LA1, LA2 and STO (Safe Torque Off) (display segment assignment: high = 1, low = 0).
Example above: LA1 and LA2 are at 0; STO (Safe Torque Off) is at 1.
Code Name / Description Unit
State 1
State 0
LI1 LI2 LI3 LI4 LI5 LI6
State 1
State 0
LA1 LA2 STO
DRI- > MON- > IOM- > LIA-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com