Installation manual

Monitoring Mode (MOn)
S1A28692 03/2010 47
Parameters described in this page can be accessed by:
AIA- [ANALOG INPUTS IMAGE] (continued)
Analog input functions.
AI3C
[AI3]
V
AI3 customer image: Value of analog input 3.
AI3A [AI3 assignment]
AI3 functions assignment. If no functions have been assigned, [No] (nO) is displayed.
Following parameters are visible on the graphic display terminal by pressing the ENT key on the parameter.
Identical to [AI1 assignment] (AI1A) page 46
.
CrL3 [AI3 min value]
mA
Current scaling parameter of 0%.
CrH3 [AI3 max value]
mA
Current scaling parameter of 100%.
AI3F [AI3 filter]
s
Interference filtering cutoff time of the low-filter.
IOM- [I/O MAP] (continued)
AOA- [ANALOG OUTPUTS IMAGE]
Analog output functions.
Following parameters are visible on the graphic display terminal by pressing the ENT key on the parameter.
AO1C
T
[AO1C]
AO1 customer image: Value of analog output 1.
AO1 [AO1 assignment]
AO1 functions assignment. If no functions have been assigned, [No] (nO) is displayed.
Identical to [AO1 assignment] (AOI) page 129
.
UOL1 [AO1 min Output]
V
g
Voltage scaling parameter of 0%. Can be accessed if [AO1 Type] (AO1t) is set to [Voltage] (10U).
UOH1 [AO1 max Output]
V
g
Voltage scaling parameter of 100%. Can be accessed if [AO1 Type] (AO1t) is set to [Voltage] (10U).
AOL1 [AO1 min output]
mA
g
Current scaling parameter of 0%. Can be accessed if [AO1 Type] (AO1t) is set to [Current] (0A).
AOH1 [AO1 max output]
mA
g
Current scaling parameter of 100%. Can be accessed if [AO1 Type] (AO1t) is set to [Current] (0A).
ASL1 [Scaling AO1 max]
%
Minimum scaling value for AO1.
ASH1 [Scaling AO1 min]
%
Maximum scaling value for AO1.
AO1F [AO1 filter]
s
Cutoff time of the low-filter.
Code Name / Description Unit
DRI- > MON- > IOM- > AIA- > AI3C
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com