Installation manual

Monitoring Mode (MOn)
48 S1A28692 03/2010
Parameters described in this page can be accessed by:
IOM- [I/O MAP] (continued)
FSI- [FREQ. SIGNAL IMAGE]
Frequency signal image.
This menu is visible only on graphic display terminal.
PFrC
[RP input]
Hz
Filtered customer pulse input frequency reference.
Following parameters are visible on the graphic display terminal by pressing the ENT key on the parameter.
PIA [RP assignment]
Pulse input assignment. If no functions have been assigned, [No] (nO) is displayed.
Identical to [AI1 assignment] (AI1A) page 46
.
PIL [RP min value]
kHz
RP minimum value. Pulse input scaling parameter of 0%.
PFr [RP max value]
kHz
RP maximum value Pulse input scaling parameter of 100%.
PFI [RP filter]
ms
Interference filtering pulse input cutoff time of the low-filter.
MOn- [1.2 MONITORING] (continued)
SAF- [MONIT. SAFETY]
For more details on Integrated Safety Functions, please refer to dedicated Safety manual.
StOS
IdLE
StO
FLt
[STO status]
Status of the Safe Torque Off safety function.
[Idle] (IdLE): STO not in progress
[Safe stop] (StO): STO in progress
[Fault] (FLt): STO fault detected
SLSS
nO
IdLE
SS1
SLS
StO
FLt
[SLS status]
Status of the Safe Limit speed safety function.
[Not config.] (nO): SLS not configured
[Idle] (IdLE): SLS not in progress
[Safe ramp] (SS1): SLS ramp in progress
[Speed limited] (SLS): SLS speed limitation in progress
[Safe stop] (StO): SLS safe torque off request in progress
[Fault] (FLt): SLS fault detected
SS1S
nO
IdLE
SS1
StO
FLt
[SS1 status]
Status of the Safe Stop 1 safety function.
[Not config.] (nO): SS1 not configured
[Idle] (IdLE): SS1 not in progress
[Safe ramp] (SS1): SS1 ramp in progress
[Safe stop] (StO): SS1 safe torque off request in progress
[Fault] (FLt): SS1 fault detected
Code Name / Description Unit
DRI- > MON- > IOM- > FSI-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com